ACME FURY LED RGB User Manual page 10

5.2 Easy Controller (by CA-8)
The easy remote control is used only in master/slave mode. By
connecting to the 1/4" microphone jack of the first unit, you will find that
the remote controller on the first unit will control all the other units for
Stand by, Function and Mode selection
.
Blackout Blackout the unit
1. SynchroStrobe
Function 2. Asynchro Strobe
3. Sound Strobe
Sound/Strobe
Mode
(LED OFF)
5.3 DMX Controller
Using universal DMX controller to control the units, you have to set DMX address from 1 to
512 channel so that the units can receive DMX signal.
Press the MENU button up to when the
button and the display will blink. Use DOWN and UP button to change the DMX512 address.
Once the address has been selected, press and keep ENTER button pressed up to when
the display stops blinking or storing automatically 8 seconds later. To go back to the
functions without any change press the MENU button again. If you use please refer to the
following diagram to address your DMX512 channel for the first 4 /2 units.
1 channel mode:
3 channels mode:
Select Show
(Show 1-8)
Show
(LED ON)
is showing on the display. Pressing ENTER
9A
Select Speed
1. Slow
2. Middle
3. Fast
LED blinking