Within the TruSpace we can then search for the target 2. Use the project layout drawing on
Figure 2 for reference.
From the TruSpace menu, use:
Seek mode to point the black & white target
•
Zoom in to the target to have a better view
•
With Pick mode choose a point near the target center
•
Choose Create Target | Black/White Target... command from the menu
•
An algorithm is searching for a right angle in the near of the picked point. With the intensity
change between black and white on the target, Cyclone is able to best fit a vertex in the center
of the target.
Visually inspect to vertex position to see if you are happy with the fitting
•
Enter "2" as TargetID in the Target Identification window
•
Press OK
•
The target is then stored in all corresponding ControlSpaces as well, which is essential to be able
to use it in our further registration process.
3.2 Acquiring Targets in the ModelSpace
Target ID 3, which is a mounted 4 ½ inch black & white target must be manually acquired from
ScanWorld "Station-003:SW-003". This time we will use the ModelSpace View to achieve this.
Registration
Figure 11
Figure 12
Module 3.1 – Applied Registration
11 - 52