Figure 55
For our exercise we will use the Auto-Add Constraints command:
•
Click on the Constraint List tab in the registration window. It is empty.
•
From the top menu select Constraint | Auto-Add Constraints
After a few seconds the view updates and list all constraints found between our 3 ScanWorlds.
Please see section 1.3 for details about the single columns.
Note the new Type of constraints using Targets
4.4 Register
To compute the global error we will register next. This time only the coordinate information of
the targets is used for the transformation.
•
Click Registration | Register
Inspect Result
•
Inspect the values in the Error and Error Vector columns
•
By clicking on the Error field the column is sorted and the biggest/smallest value can be easily
identified.
Since the ScanWorlds are not grouped yet no value is shown under Group Error
and Group Error Vector.
Registration
•
In the Dialog several options are available
•
Click on Info button for further details on
the settings
Figure 56
Figure 57
Module 3.0 – Basic Registration
27 - 30