11
SERVICE WORK ON THE CHASSIS
11.7
Removing the fork legs
11.8
Installing the fork legs
–
Position the fork protector on the left fork leg. Mount and tighten screws
Guideline
Remaining screws, chassis
–
Position the brake line and clamp. Mount and tighten screws
S01482-11
Preparatory work
–
Raise the motorcycle with a lift stand. (
–
Remove the front wheel.
Main work
–
Remove screws
–
Remove screws
–
Allow the brake caliper and brake line to hang loosely to the side.
Info
Do not kink the brake line.
S01484-10
–
Loosen screws
–
Loosen screws
S01485-10
Main work
–
Position the fork legs.
Bleeder screws
Info
The second milled groove (from the top) must be flush with the top edge of
the upper triple clamp.
S01480-10
–
Tighten screws
Guideline
Screw, top triple clamp
–
Tighten screws
Guideline
Screw, bottom triple clamp
S01485-11
M6
p. 31)
(
p. 67)
and take off the clamp.
and take off the brake caliper.
. Remove the left fork leg.
. Remove the right fork leg.
are positioned toward the rear.
.
M8
.
M8
33
.
10 Nm (7.4 lbf ft)
.
20 Nm (14.8 lbf ft)
15 Nm (11.1 lbf ft)