Service Schedule; Additional Information; Required Work - Husqvarna TC 65 Owner's Manual

Table of Contents

Advertisement

9

SERVICE SCHEDULE

9.1

Additional information

Any further work that results from the required work or from the recommended work must be ordered separately and can be
invoiced separately.
9.2

Required work

Check the front brake linings. (
Check the rear brake linings. (
Check the brake discs. (
Check the brake lines for damage and leakage.
Change the foot brake cylinder seals.
Check the rear brake fluid level. (
Check the free travel of the foot brake lever. (
Check the frame and swingarm.
Check the swingarm bearing for backlash.
Check the heim joint for play.
Check the tire condition. (
Check the tire air pressure. (
Check the wheel bearing for play.
Check the wheel hubs.
Check the rim run-out.
Check the spoke tension. (
Check the chain, rear sprocket, engine sprocket and chain guide. (
Check the chain tension. (
Grease all moving parts (e.g., hand lever, chain, ...) and check for smooth operation.
Check the fluid level of the hydraulic clutch. (
Check the front brake fluid level. (
Check the free travel of the hand brake lever. (
Check play of steering head bearing. (
Change the gear oil.
(
Check the gear oil level. (
Check the clutch.
Check all hoses (e.g. fuel, cooling, bleeder, drainage, etc.) and sleeves for cracking, leaks, and incorrect rout-
ing.
Check the antifreeze and coolant level. (
Check the cables for damage and routing without sharp bends.
Check that the throttle cables are undamaged, routed without sharp bends, and set correctly.
Clean the air filter and air filter box.
Change the glass fiber yarn filling of the main silencer.
Check the screws and nuts for tightness.
Change the spark plug.
Check idle.
Final check: Check the vehicle for safe operation and take a test ride.
Make the service entry in Husqvarna Motorcycles Dealer.net and in the Service and Warranty Booklet.
One-time interval
Periodic interval
p. 59)
p. 64)
p. 57)
p. 63)
p. 61)
p. 70)
p. 70)
p. 70)
p. 50)
p. 54)
p. 58)
p. 57)
p. 36)
p. 78)
p. 78)
p. 72)
(
p. 45)
p. 51)
(
p. 47)
Every 40 operating hours
Every 20 operating hours
Once after 10 operating hours
21

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tc 50 2017

Table of Contents