13
WHEELS, TIRES
13.4
Installing the rear wheel
Warning
Danger of accidents Oil or grease on the brake discs reduces the braking effect.
–
Always keep the brake discs free of oil and grease.
–
Clean the brake discs with brake cleaner when necessary.
–
Remove spacers
H00936-10
Main work
–
Check the wheel bearing for damage and wear.
»
If the wheel bearing is damaged or worn:
–
Change the rear wheel bearing.
–
Clean and grease shaft seal rings
Long-life grease (
–
Insert the spacers.
H01173-10
Info
Insert the wide spacer on the left in the direction of travel.
–
Clean and grease wheel spindle
Long-life grease (
–
Position the rear wheel and insert wheel spindle.
The brake linings are correctly positioned.
–
Mount the chain.
–
Position chain adjuster
way.
E00543-10
–
Mount nut
–
Make sure that the chain adjusters are fitted correctly on the adjusting screws.
–
Check the chain tension. (
–
Tighten nut
Guideline
Nut, rear wheel spindle
–
Operate the foot brake lever repeatedly until the brake linings are in contact with
the brake disc and there is a pressure point.
E00544-10
Finishing work
–
Remove the motorcycle from the lift stand. (
.
p. 92)
.
p. 92)
on both sides and push the wheel spindle in all the
, but do not tighten it yet.
p. 50)
.
and mating surfaces
of the spacers.
M14x1.5
40 Nm (29.5 lbf ft)
p. 31)
69