Husqvarna TC 65 Owner's Manual page 62

12 BRAKE SYSTEM
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with the applicable
regulations.
Info
Never use DOT 5 brake fluid. It is silicone-based and purple in color. Oil seals and brake lines are not designed for DOT 5
brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint.
Only use clean brake fluid from a sealed container.
–
Move the brake fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws
–
Remove cover
E00556-10
–
Remove lock washer
–
Loosen screw
–
Remove screws
–
Carefully pull the brake caliper backward from the brake disc.
–
Remove screw
Warning
Danger of accidents Oil or grease on the brake discs reduces the brak-
ing effect.
E00557-10
–
–
–
Check the brake discs. (
–
Remove the brake linings.
–
Clean the brake caliper and brake caliper support.
–
Press the brake piston back into the basic position and ensure that brake fluid
does not flow out of the brake fluid reservoir, sucking it away if necessary.
E00558-10
Warning
Danger of accidents Brake linings which have not been approved alter
the braking efficiency.
Not all brake linings are tested and approved for Husqvarna motorcycles.
The structure and friction coefficient of the brake linings, and thus their
brake power, may vary greatly from that of original brake linings.
If brake linings are used that differ from the original equipment, compli-
ance with the original homologation is not guaranteed. In this case, the
vehicle no longer corresponds to its condition at delivery and the war-
E00559-10
ranty shall be void.
–
–
Position the new brake linings.

.
 
with membrane

.

.

.

.
Always keep the brake discs free of oil and grease.
Clean the brake discs with brake cleaner when necessary.
p. 57)
Only use brake linings approved and recommended by Husqvarna
motorcycles.
.
60