Refilling With Coolant - Husqvarna TC 65 Owner's Manual

14 COOLING SYSTEM
14.5

Refilling with coolant

Warning
Danger of poisoning Coolant is toxic and a health hazard.
–
Keep coolant out of the reach of children.
–
Do not allow coolant to come into contact with the skin, the eyes and clothing.
–
Consult a doctor immediately if coolant is swallowed.
–
Rinse the affected area immediately with plenty of water in the event of contact with the skin.
–
Rinse eyes thoroughly with water and consult a doctor immediately if coolant gets into the eyes.
–
Change clothing if coolant spills onto your clothing.
–
Position the motorcycle upright.
–
Place a suitable container under the water pump cover.
–
Remove screw
–
Completely drain the coolant.
–
Mount and tighten screw
Guideline
Drain plug, water pump cover
E00540-10
Main work
–
Make sure that screw
–
Position the motorcycle upright.
–
Add coolant to level
Guideline
Distance
Coolant
E00539-10
–
Move the vehicle into the position shown and prevent it from rolling away. Height
difference
Guideline
Height difference
Info
0 0 A A 0 0 B B For all of the air to be able to escape from the cooling system, the vehicle
must be raised at the front. If the cooling system is poorly de-aerated, its
cooling power will be reduced and the engine may overheat.
400677-11
–
Return the vehicle to the horizontal position.
–
Add coolant to level
–
Mount the radiator cap.
Finishing work
–
Go for a short test ride.
–
Check the cooling system for leaks.
–
Check the coolant level. (

. Remove the radiator cap.

with a new seal ring.

is tightened.

.

above the radiator fins
0.55 l (0.58 qt.)

must be reached.


.
p. 73)
M6 6 Nm (4.4 lbf ft)
10 mm (0.39 in)
Coolant ( p. 90)
50 cm (19.7 in)
74