Prru Cable List - Huawei DBS3900 Installation Manual

Hide thumbs Also See for DBS3900:
Table of Contents

Advertisement

DBS3900 LampSite
Installation Guide
Special Cabling Requirements
Cabling of PGND cables

9.4.2 pRRU Cable List

This section describes pRRU cables, connectors added to the pRRU cables, and installation
positions for both ends of each cable.
Table 9-4 List of pRRU3901 cables
Cable
Ethernet
Cable
(Optional)
RF Jumper
Issue 08 (2016-05-30)
Determine the positions where the clips are installed according to the actual situation.
For example, 7/8" feeders are secured with clips at an interval of 1.5 m (4.92 ft) to 2 m
(6.56 ft), and CPRI fiber optic cables and power cables are secured with clips at an
interval of 1 m (3.28 ft) to 1.5 m (4.92 ft). Ensure that the clips are evenly spaced and in
the same direction.
When fastening cables with a clip, ensure that the cables are aligned neatly and are
routed through the holes in the clip. Do not stretch the cables too tightly.
When using clips to secure cables, tighten the screws on the clips after all cables are
arranged and laid out.
PGND cables for a base station must be connected to the same ground bar.
PGND cables must be buried in the ground or routed indoors.
The external conductor of the coaxial wire and the shield layer of the shielded cable must
have proper electrical contact with the metal surface of the equipment which they are
connected to.
PGND cables and signal cables must be installed separately. A certain distance must be
reserved between them to prevent interference from each other.
Switches or fuses must not be installed on the PGND cables.
Other devices must not be used for electrical connections of the PGND cables.
All the metal parts in the housing of the equipment must be reliably connected to the
ground terminal.
One End
Connector
RJ45 connector
RJ45 connector
SMA straight
male
connector/Type
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 Installing a pRRU3907 or pRRU3916
The Other End
Connected
Connector
to ...
CPRI_E0~CP
RJ45 connector
RI_E7 port on
RHUB
Transmission
RJ45 connector
port on Access
Control(AC)
External
Based on the
antenna
port model of
TX/RX RF
the antenna
Connected to ...
CPRI_E0~CPRI_
E1 port on pRRU
GE port on
pRRU3901
CPRI_E1 port
on
pRRU3911/p
RRU3911+WI
FI
Antenna system
189

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents