Attaching An L-Shaped Label - Huawei DBS3900 Installation Manual

DBS3900 LampSite
Installation Guide
NE
Label Structure
Using the RHUB power label as an example, Figure 15-7 shows the structure of a DBS3900
LampSite engineering label.
Figure 15-7 Label structure

15.4 Attaching an L-Shaped Label

This section describes the procedure and precautions to be taken for attaching an L-shaped
label.
Issue 08 (2016-05-30)
Label Content
Antenna
label
 In the label, RHUB and pRRU identify the specific DBS3900 LampSite NEs.
 If only one RHUB is deployed, mark it as RHUB0 on the label. If multiple RHUBs are deployed,
mark them in ascending sequence, beginning with RHUB0.

If only one pRRU is deployed, mark it as pRRU0 on the label. If multiple pRRUs are deployed,
mark them in ascending sequence, beginning with pRRU0.

For details about the maximum number of RHUBs and pRRUs in the DBS3900 LampSite solution,
see Typical Configurations in DBS3900 LampSite Technical Description.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Description
pRRUy Label for the pRRUy RF
Jumper.
ANTa
 y specifies the number
of pRRUs and cannot
exceed the maximum
pRRU number
supported by the
networking.
 a can be set to 0 to 5,
which respectively
correspond to ANT0
port and ANT5 port of
the pRRU.
15 Appendix
Corresponding
port on the base
station
ANT0 to ANT5
278