Attaching A Sign Plate Label - Huawei DBS3900 Installation Manual

DBS3900 LampSite
Installation Guide
Figure 15-10 Turning over the labeling area along the adhesive face
Figure 15-11 Attached engineering label
Step 5 Fill in the attached blank label by referring to 15.3 DBS3900 LampSite Engineering Label.
----End

15.5 Attaching a Sign Plate Label

This section describes the procedures and precautions for attaching a sign plate label.
Context


Procedure
Step 1 Lead the cable ties through the holes of a label, and then bind the label to the cable, as shown
in Figure 15-12. Ensure that the cable ties are led through the holes of the label in the same
direction.
Issue 08 (2016-05-30)
This section applies to Huawei sign plate labels. If other engineering labels in
accordance with local standards are used on site, follow the local standards for attaching
sign plate labels.
A sign plate label is usually used for a power cable, ground label, signal cable, and
antenna. This section uses 15.3 DBS3900 LampSite Engineering Label as an example.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
15 Appendix
280