Quick Recipe; Daily Use; Filling (Up) The Canisters; Preparations - Animo OptiFresh 1 Manual

6.2 Quick recipe

With the quick recipe (¿ g. 25) you can easily adjust the
volume and the strength of the used ingredients such
as coffee, milk (topping), cocoa and/or sugar for each
drink (recipe).
The quick recipe menu is only available if it has been
activated by the service engineer.
Only the ingredients that are relevant for the recipe
in question are shown.
The example below shows how you can increase the
volume and quantity of milk in the recipe for coffee
Milk & Sugar.
If the volume is increased, the coffee strength
is automatically proportionately adjusted.
Ingredients such as topping and sugar are
also adjusted automatically.
If after you set the volume, you are not satis¿ ed
with the strength of the coffee, you can adjust
the quantity of ground coffee. Of course, other
ingredients like topping and sugar can also be
adjusted separately.
1. Open the operator menu (¿ g. 25)
2. Go to 1.4 Quick recipe and press enter.
3. Go to the recipe you wish to change Recipe: Coffee
Mlk Sgr and press enter twice.
4. The display shows the set volume. Change the
volume to 150 ml and press enter to accept the new
setting.
5. Go to Strength: Topping and press enter. Increase
the dosage of milk by 5% and press enter to accept
the new setting.
6. TESTING: after the volume and/or strength
ingredient has been adjusted, a blue LED starts
À ashing next to one of the dispensing buttons.
Place a cup under the outlet in question and
press the relevant dispensing button. Your drink is
now prepared according to the changed settings.
7. Assess the drink's volume and taste. Repeat these
actions for this drink or other drinks if necessary.
1
2
3
4
5
6
70 07/2009 Rev. 0.9

7. DAILY USE

7.1 Filling (up) the canisters

Never ¿ ll the ingredient canisters with more than what is
required for one day in order to ensure that the products
remain fresh at all times!
Always ensure that the transport auger is covered in
approx. 3 cm of ingredient. Shake canister(s) containing
plenty of product to prevent the contents from 'caving in'.
To ¿ ll up the canisters, you must remove them from the
device.
1. Take the canister(s) from the device by pulling it/
them towards you.
2. Fill the canister(s) with the appropriate product (¿ g. 24).
Only ¿ ll the wide canister with fresh brew
coffee! Your machine can have two narrow
optional fresh brew canisters for decaffeinated
coffee.
Fill the narrow canisters with instant products
such as topping, cocoa (see table 2 on page 16).
3. Place the canister(s) back into the machine in the
right order. Make sure that the drive mechanism of
the canister falls over the cog in the back wall and
that the fastening ridge goes into the hole of the
plate (¿ g. 25).
4. Turn the dispensing element(s) back to their correct
position (¿ g. 26).
Make sure that the correct canister is placed in its
rightful place (see numbers on the canister and the
device).
Rinse off any product that was spilt in the mixer(s) by
using the cleaning programme.

7.2 Preparations

1. Turn on the device by using the main switch.
Fig. 25
The display lights up.
2. Close the door and lock it.
3. The device is ¿ lled [Boiler ¿ lling] and then starts
heating the water [Boiler Heating].
4. If necessary, ¿ ll up the canister(s) when the boiler is
heating up.
5. Once the device has warmed up, the display shows
[Make your choice].
6. Place an empty collection tray under the outlet and
carry out the brewer and mixer rinsing programme.
7. The device is now ready for use.
07/2009 Rev. 0.9
Fig. 26
Fig. 27
Fig. 28
Fig. 29
71