Connect The Mix Manifold To The Gun; Connect Tank Heat Circulation Hoses; Prime Heated Hose Bundle Fluid Circulation System - Graco XM 24W626 Operation Manual

Setup
Connect the Mix Manifold to the
Gun
The following parts are supplied loose. Connect them to
the mix manifold as follows. See F
1. Connect 1/2 in. ID x 2 ft hose to mix manifold (R)
outlet.
R
F . 24
IG
2. Connect static mixer (S).
3. Connect 1/2 in. ID x 10 ft. hose.
4. Connect 1/2 in. x 3/8 in. nipple.
5. Connect 3/8 in. ID x 3 ft hose.
6. Connect 1/2 x 3/8 nipple.
7. Connect swivel.
8. Connect gun (T).
Connect Tank Heat Circulation
Hoses
NOTE: The tank jacket heat circulation system was
pre-filled at the factory.
The tank to tank circulation hoses use quick-disconnect
fittings that were connected back to their own tank for
shipping.
Disconnect these fittings and connect them back to the
opposite tank as shown in F
26
. 24.
IG
S
T
ti20090a
. 25 or F . 26.
IG IG
Prime Heated Hose Bundle Fluid
Circulation System
The heated fluid circulation system includes heated
hoses alongside the material hoses for the length of the
hose bundle, heated fluid circulation through the mix
manifold, and heated fluid circulation through the tank
double-wall which is insulated by a jacket.
See instructions on page 29.
3A2776H