Installing The Lighting Pinshield - Ingenico iUP 250 Integration Manual

7.7.2 Installing the Lighting pinshield

The Lighting pinshield will light the keypad thanks to 4 LEDs. It is connected to the
iUP250 by a cable plugged on the right side. The pinshield is installed on the kiosk
using 6 screws M4 x 10.
4 wedges are provided to fill the gap between the keypad and the pinshield according
to the kiosk panel thickness. One has to be selected as follow:
Kiosk panel thickness
2 mm
3 mm
4 mm
5 mm
Light module with cable
Picture showing installation of the iUP250 lighting pinshield.
Intégration Guide_iUP250&iUR250
900009151 R11 000 01/1223
Wedge to use
Wedge thickness 2.5
Wedge thickness 3.5
Wedge thickness 4.5
Wedge thickness 5.5
Wedge
70/83 Copyright © 2012 Ingenico
All rights reserved