Kiosk Preparation For Iup250 New Installation - Ingenico iUP 250 Integration Manual

7.2 KIOSK PREPARATION FOR IUP250 NEW
INSTALLATION
iUP250 uses EVA mounting standard with additional fixing studs. It requires a cut out
in the kiosk to the dimensions detailed in the diagram below (all dimensions are in
millimeters).
The drawing below shows the footprint of iUP250 product.
CAUTION:
It is important that the iUP250 footprint surface on the kiosk must be flat and cleared
of any holes and burrs.
Special attention is required for anti-removal switches area.
3D step files are also available upon request.
Fixing must be done by 6 M4x16mm welded studs.
Drawing of the cut-out for the iUP250 3D design on demand.
Intégration Guide_iUP250&iUR250 63/83 Copyright © 2012 Ingenico
900009151 R11 000 01/1223 All rights reserved