15.1 Initializing HDDs
Purpose:
A newly installed hard disk drive (HDD) must be initialized before it can be used with your NVR.
A message box pops up when the NVR starts up if there exits any uninitialized HDD.
Click Yes button to initialize it immediately or you can perform the following steps to initialize the
HDD.
Step 1 Go to Menu >HDD >General.
Step 2 Select HDD to be initialized.
Step 3 Click the Init button.
Step 4 Select the OK button to start initialization.
Network Video Recorder User Manual
Chapter 15 HDD Management
Figure 15-1 Message Box of Uninitialized HDD
Figure 15-2 HDD Information Interface
Figure 15-3 Confirm Initialization
207