GCC Technologies LaserPro X252RX User Manual page 78

protruding lines are from the square's ideal edge, the larger you will need to set the Image
Tuning value to compensate.
The following is an example that has the proper image tuning, and demonstrates this significance
when engraving fine, small, intricate text. The following two pictures show engraved text
magnified with no image tuning (left picture) and image tuning enabled (right picture).
Rotary Fixture (Paper Page) [DEFAULT SETTING: Unselected]
NOTE
This option is only to be used with the Rotary Attachment optional accessory properly set up.
For instructions on how to set up the Rotary Attachment, please refer to Chapter VII of this
manual.
You will need to select this option when processing a job with the optional rotary attachment
system to engrave on round or cylindrical objects. When you have your material and rotary
attachment properly set up:
1) Check the Rotary Fixture function and notice the change in the Paper Size fields under Paper
Size, the X value represents the length of your work piece. Enter the length of your work piece
in this field.
2) Under Paper Size, the Diameter value represents the diameter of your working piece (at the
position you wish to engrave). Enter the diameter of your work piece in this field. Again,
remember the proper diameter value would be the diameter location, at the point of engraving
on your work piece.
3) Under Rotary Parameter, the Offset value represents distance from the open end of your work
piece to the base of the padded rubber wheel. This value will be displayed on the LCD panel.
Enter the proper offset value in this field.
Square's Left Edge
67
Square's Right Edge
232001240G(08)