Smartair Fine / Ultra Nozzles Option - GCC Technologies LaserPro X252RX User Manual

3) Open the front pass-through door and lower the LaserPro X252RX & X380RX's worktable to lowest
possible position through the X252RX & X380RX control panel.
4) Insert the cutting box through the open front pass-through door onto the worktable, with the Fume
Extraction opening facing towards the back end of the LaserPro X252RX & X380RX. Ensure the rear
and left side of the cutting box is aligned flush to the edges of the left and right rulers on the worktable.
5) Find the four screw holes at the bottom of the cutting box. With the included thumbscrews, secure the
cutting box to the worktable.
6) On the front right hand side of the cutting table, there will be a metal guard, which must be swiveled so
that it is perpendicular to the front side of the cutting table (as shown in the picture below). This allows
the LaserPro X252RX & X380RX to properly account for the extra height the cutting table adds to the
cutting table.
CAUTION
Damage may occur to the system if you try to raise the work table without proper setting
of the metal guard.
7) Now position the included material support stands so they support the thick, firm material you will be
working with, while avoiding the laser path. In other words, avoid placing the support stands underneath
any section of the material that will be lasered, especially during laser cutting.

7.4 SmartAIR Fine / Ultra Nozzles Option

The SmartAIR™ Fine and Ultra Nozzles minimize flaming, suppress working temperatures, and blow away
dust and particle byproducts generated from the laser process.
The SmartAIR Fine Nozzle is recommended for engraving or cutting thin material such as textile. The smaller
caliber nozzle is positioned closer to the object for a concentrated blast directed over a small area to eliminate
burning on the cutting edge. The vertical design of the SmartAIR Fine Nozzle produces a concentrated airflow
to blow away dust and unwanted residue, leaving a clean product surface.
The SmartAIR Ultra Nozzle is recommended for cutting thick material such as acrylic. The larger caliber
nozzle produces strong airflow over a wider area to prevent flaming when the laser is cutting at slower speeds.
NOTE
The LaserPro X252RX & X380RX comes standard with the SmartAIR Standard Nozzle,
but for specialized jobs on specific materials, we highly recommend the use of the
SmartAIR Fine or Ultra Nozzles.
INSTALLATION:
1) Unscrew the thumbscrews securing the front plate of the laser head, and remove the faceplate.
2) Remove the currently installed nozzle by simply sliding it outwards (towards you).
3) With either the SmartAIR Fine or Ultra Nozzle, simply slide into the slot (where you removed the
original nozzle), with the pointed end face down.
4) Position the faceplate back onto the laser head and screw the thumbscrews back into place.
90
232001240G(08)