Chapter V - Operating The Laserpro X252Rx & X380Rx; Using The Hardware; Adjusting The Lcd Display Screen's Contrast Setting; Laser Key Switch - GCC Technologies LaserPro X252RX User Manual

Chapter V - Operating the LaserPro X252RX & X380RX
Once you have installed the LaserPro USB Driver (USB connectivity only), LaserPro Print Driver,
and have connected the LaserPro X252RX & X380RX to your computer, you will need to
familiarize yourself with the LaserPro X252RX & X380RX's control panel and LaserPro Print
Driver. The print driver will be where you spend most of your time configuring specific laser
parameters for your jobs, while the control panel will allow you to set repeat times, manipulate the
file order, perform auto / manual focusing, configure the start point, and more.

5.1 Using the Hardware

5.1.1 Adjusting the LCD Display Screen's Contrast Setting

Depending on the lighting of your immediate work area, you may need to adjust the LCD display
screen's contrast. You may increase or decrease the display screen's contrast via the contrast
adjustment wheel found on the inside of the front cover on the bottom, right side. You can access
this area by opening the top window and looking inside to the near, right side of the work area (as
shown in the picture below).
* The contrast adjustment dial is locating underneath the control panel

5.1.2 Laser Key Switch

Turn the key-switch to the "ON" position BEFORE powering on the machine. If
the key-switch is turned to the "OFF" position, the laser will be disabled meaning
that the laser will not fire although the XY motion system will still move.
34
LCD Display Screen's
Contrast Adjustment Wheel
232001240G(08)