GCC Technologies LaserPro X252RX User Manual page 104

D. Use the flat surface as shown in picture below as a reference point and tighten the first screw against it.
After doing so, tighten the second screw and the rotary attachment is ready for use.
INSTALLATION:
1) Turn off the power of the engraver before installing the Rotary attachment.
2) Set the rotary attachment onto the engraving table so that the bottom mounting screws
correspond to the positional holes on the engraving table. In addition, the top end of the rotary
attachment must be leveled against the engraving table with the rotary's positional indicator
(center point of the top of the rotary attachment) aligned to the center position on the
engraver's vertical axis.
3) With the rotary attachment properly positioned, tighten the mounting screws to secure
the rotary attachment.
4) Open the front panel of the X252RX/ X380RX and connect the rotary attachment cable
to the rotary attachment port located inside the X252RX/ X380RX's front panel
(shown in the picture below).
5) Close the front panel.
6) The rotary attachment is now properly installed. Power on the X252RX/ X380RX and the rotary
attachment will be automatically detected and the engraving table will automatically move to its
lowest position.
7) Despite the dummy-proof installation design, please ensure that the device is installed correctly
before turning on the machine
93
Flat surface
1. Tighten this against the flat
surface
2. Tighten the second screw
Rotary Attachment Port
232001240G(08)