8.2 Maintaining the Worktable and Motion System
8.2.1 Accessing the Worktable and Motion System
Remove the screws of the top of the machine and lift the top off.
8.2.2 Cleaning the Worktable and Motion System
8.2.2.1 Cleaning the Worktable and Motion System
Clean the working table and the motion system on a weekly basis through the following steps:
1) Turn the power off and unplug the X252RX & X380RX before cleaning.
2) Use a vacuum cleaner with a flexible nozzle to remove dust and debris from the worktable and
motion system.
3) Apply small amounts of all-purpose cleaner, alcohol, or acetone to a paper or cotton towel to
clean the working table.
4) Apply a soap solution, all-purpose cleaner, or alcohol to a paper or cotton towel to wipe down the
rails of the motion system.
5) Wait for all cleaning residue to dry completely before plugging in and operating the X252RX &
X380RX.
CAUTION
•
Never pour or spray alcohol or acetone directly to the working table.
•
Oil, alcohol and acetone can cause fires or smoke build-up if improperly used.
TIP
Please clean the AutoFocus pin each time after completing the engraved job to make sure the
AutoFocus pin is free to move.
Eclipse Cleaning System Solution
96
232001240G(08)