Set Table Down Page
The Set Table Down Page allows you to select whether or not the LaserPro X252RX & X380RX
displays a warning prompt at startup. If the Table Down selection is set to <YES>, the LaserPro
X252RX & X380RX will display a "Table will move down and remove objects on table" warning
prompt on startup. Pressing the Enter key at this point will confirm the prompt to move the work
table to its lowest position. If the Table Down is set to <NO>, then the LaserPro X252RX &
X380RX will not display this warning prompt at system startup.
Table Down: YES / NO
Distance: 0 - 165 mm
Relevant Buttons
F1 (Back)
F4 (Save)
/
Directional
/
Directional
Start / Stop
Auto Focus
▲ / ▼ Manual Focus
Buttons
☼ Navigating to this page:
Set Table Down Page
Back to previous page
Save your current settings
Scroll through the menu selections
Adjust the value for that selection
Back to Main Work Page
Initiate the auto focus function
Manually adjust the height of the work table (Z-
axis)
- 39 -
Main Work Page
Press F4
Functions Page
Select <Machine Setting>
from the menu
Machine Setting Page
Select <Set Table Down>
from the menu
Set Table Down Page
Function
232001240G(08)