GCC Technologies LaserPro X252RX User Manual page 105

OPERATION:
1) Use a ruler to measure the diameter (at the point on the work piece you will be engraving) and
length of the work piece you will be engraving. Make a record of this.
2) Load the work piece onto the rotary attachment by first listing the lever on the rotary
attachment, unlocking the adjustable end of the rotary attachment. Slide the adjustable end to
accommodate the length of the work piece. Load the working piece by centering the open end
of the work piece against the rubber wheel and slide the adjustable end to fit the bottom of
work piece firmly. Now simply lower the lever to secure the work piece with the rotary
attachment.
If your work piece is small, please apply 4" focal lens for operation to prevent the lens
carriage from colliding with the rotary attachment.
3) Prepare the graphic you would like to engrave with the rotary attachment and go to the Paper
Page of the print driver.
NOTE
Please refer to section 5.2 of the reference manual for complete instructions on how to use
the X252RX/ X380RX's Print Properties.
4) From the Paper Page, the first thing you must do is to check the Rotary Fixture. The Paper
Size options and Rotary Parameter will change to allow for proper input based on your rotary
attachment.
5) Under Paper Size, the X value represents the length of your working piece. Enter the length
of your work piece in this field.
6) Un n d d e e r r P P a a p p e e r r S S i i z z e e , , t t h h e e D D i i a a m m e e t t e e r r v v a a l l u u e e r r e e p p r r e e s s e e n n t t s s t t h h e e d d i i a a m m e e t t e e r r o o f f y y o o u u r r w w o o r r k k i i n n g g
pi i e e c c e e (at the position you wish to engrave). Enter the diameter of your work piece in this field.
Again remember the proper diameter value would be the diameter location on your work piece you
will be engraving.
7) Under Rotary Parameter, the Offset value represents distance from the open end of your work
piece to the base of the padded rubber wheel. This value will be displayed on the X252RX/
X380RX's LCD panel. Enter the proper offset value in this field.
8) Your X252RX/ X380RX print driver settings are now properly set. Manually position the laser
carriage to the proper X / Y location on the object you will be engraving and position the auto
focus pin over the area to be engraved on your work piece. Hit the Auto Focus button and the
X252RX/ X380RX will now properly focus at the location to be engraved.
9) Go back to the X252RX/ X380RX Print Driver to print your design and let the engraving begin.
10) Despite the dummy-proof installation design, please ensure that the device is installed correctly
before turning on the machine
CAUTION
94
232001240G(08)