Lubrication Of The X / Y Rails; Cleaning The Optics System; Removing The Mirrors - GCC Technologies LaserPro X252RX User Manual

Laserpro x-series laser non-metal cutter and engraver

Table of Contents

8.2.2.2 Lubrication of the X / Y Rails

In order to keep the motion system running smoothly, the X / Y rails of the motion system will need

lubrication on a weekly basis. Use a small amount of light grade machine grease to a paper or cotton

towel and apply to the rails.

NOTE

• Always clean and lubricate the rails after working with materials that produce lots of

debris (such as wood).

• Too much oil applied to the X / Y rails will accelerate the build up of debris.

We recommend you check the mirrors once or twice a week to see if they require cleaning. If any

debris or smoke residue is present, use the following steps to clean them.

NOTE

•

It is highly recommended you remove, clean and replace each mirror one at a

time!

•

Refer to section 8.2.2 on how to clean the mirrors.

The following section will detail how to access and remove each of the four mirrors found on the

LaserPro X252RX & X380RX for cleaning.

Mirror 1

This mirror is located inside the laser cabinet of the LaserPro X252RX & X380RX.

1) Use a #2 Phillips Screwdriver to open the rear laser cabinet of the LaserPro X252RX &

X380RX.

2) Loosen the thumbscrew and remove the dust cover securing the mirror. (As shown in the

picture below).

232001240G(08)

Table of Contents

Show Quick Links

Table of Contents

Laserpro x380rx