Mirror 2
1) Unscrew and remove the black dust cover covering mirror 2.
2) Unscrew the thumbscrew holding mirror 2 in place.
3) Clean the lens in the proper manner.
4) Re-install mirror 2 after cleaning.
5) Tighten the thumbscrew.
6) Replace and secure the black dust cover.
Mirror 3
1) Unscrew the thumbscrew holding mirror 3 in place.
2) Clean the lens in the proper manner.
3) Re-install mirror 3 after cleaning.
4) Tighten the thumbscrew.
Mirror 4
1) Unscrew the three thumbscrews (front face of the laser head) securing the laser carriage
panel and remove the laser carriage panel to reveal mirror 4 and the focal lens.
2) Loosen the top thumbscrew to remove mirror 4 (as shown in the picture below).
Reflection mirror
3) Clean the lens in the proper manner.
4) Re-install mirror 4 after cleaning.
5) Tighten the top thumbscrew.
6) Reinstall the laser carriage panel and tighten the three thumbscrews.
8.2.2 Cleaning the Mirrors
After you have removed each mirror, you will want to inspect each mirror for scratches, smoke residue,
or debris. If any residue or debris is present, use the following steps to clean the mirror.
1) Hold the mirror with the reflective side up, without touching the reflective side of the mirror (DO
NOT apply any finger pressure or any other cleaning solutions to the mirror surface).
2) Drape a new sheet of lens tissue over the mirror.
99
Focus lens
232001240G(08)