Assembly 3.1 Scope Of Delivery; Transport - Optimum OPTIDRILL B 17PRO Operating Manual

OPTIMUM
M A S C H I N E N - G E R M A N Y
3 Assembly
INFORMATION
The drilling machine comes disassembled due to packaging reasons.
Before commissioning, the drilling machine has to be assembled.
3.1 Scope of delivery
When the machine is delivered, check immediately that the drilling machine has not been dam-
aged during transport and that all components are included. Remove all parts from the card-
board box and compare them with the following list.

Drill head

Drilling table

Base

Upright component (table support pre-assembled)

RÖHM quick-action drill chuck

Clamping lever

Crank handle

Levers for spindle sleeve feed

Operating manual
3.2

Transport


Centres of gravity

Load suspension point
(marking the positions for the
attachment position gear)

Prescribed transportation position
(Marking of the top surface)

Means of transport to be used

Weights
WARNING!
Severe or fatal injuries may occur if parts of the machine tumble or fall down from the
forklift truck or from the transport vehicle. Follow the instructions and information on
the transport case.
WARNING!
The use of unstable lifting and load suspension gear that might break under load can
cause severe injuries or even death.
Check that the lifting and load suspension gear has sufficient load capacity and that it is
in perfect condition. Observe the accident prevention regulations issued by your
Employers Liability Insurance Association or other competent supervisory authority,
responsible for your company.
Fasten the loads properly. Never walk under suspended loads!
GB B17Pro | B23Pro | B26Pro | B33Pro
Page 22 Original operating instructions
Assembly
Version 2.0.2 2014-11-04