Safety; Drill Depth Stop; Inclination Table - Optimum OPTIDRILL B 17PRO Operating Manual

OPTIMUM
M A S C H I N E N - G E R M A N Y
4.2

Safety

Use the drilling machine only under the following conditions:

The drilling machine is in proper working order.

The drilling machine is used as prescribed.

The operating manual is followed.

All safety devices are installed and activated.
All failures should be eliminated immediately. Stop the machine immediately in the event of any
abnormality in operation and make sure it cannot be started-up accidentally or without authori-
sation. Notify the person responsible immediately of any modification.

4.2.1 Drill depth stop

When drilling several holes of the same
depth you can use the drill depth stop.

Loosen the locking screw and turn the
graduated collar until the required drill-
ing depth matches with the indicator.

Re-tighten the locking screw.
The spindle can now only be lowered to the set depth.

4.2.2 Inclination table

The drilling table can be inclined to the
right or to the left.

Loosen the fixing screw.

Pull out the threaded pin.
INFORMATION
If you can not pull out the threaded pin, so the seat can be solved by turning at the nut clock-
wise.

Set the desired angle using the scale.

Re-tighten the fixing screw again.
INFORMATION
The threaded pin is only provided for correct positioning of a horizontal level of the drilling table.
GB B17Pro | B23Pro | B26Pro | B33Pro
Page 32
Locking screw
Drill depth stop
Scale
Img.4-2:
Fixing screw
Threaded pin
Scale
Img.4-3:
Original operating instructions
Scale of drill depth stop
Fixing screw
Version 2.0.2
Operation
2014-11-04