Scope Of Delivery; Set-Up And Assembly; Requirements Regarding The Installation Site; Assembly - Optimum Optidrill B 24H Operating Manual

3.2

Scope of delivery

When the machine is delivered, please check immediately that it has not been damaged during
transport. Compare the scope of delivery with the attached packing list.
3.3

Set-up and assembly

3.3.1

Requirements regarding the installation site

Organize the working area around the drilling machine according to the local safety regulations.
INFORMATION
In order to attain good functionality and a high processing accuracy as well as a long service life
of the machine, the place of installation should fulfil certain criteria.
Please observe the following points:
The device must only be installed and operated in a dry and well-ventilated place.

Avoid places near machines generating chips or dust.

The installation site must be free from vibrations also at a distance of presses, planing

machines, etc.
The ground must be suitable for the drilling machine. Make sure that the floor has sufficient

load-bearing capacity and is level.
The ground must be prepared in a way that potential coolants cannot penetrate the floor.

Any parts sticking out such as stops, handles, etc. have to be secured by measures taken

by the customer if necessary in order to avoid endangering persons.
Provide sufficient space for the personnel preparing and operating the machine and trans-

porting the material.
Also make sure the machine is accessible for setting and maintenance works.

Provide for sufficient backlight (Minimum value: 500 lux, measured at the tool tip). At lower

illumination intensities, additional illumination has to be ensured e.g. by means of a sepa-
rate workplace lamp.
INFORMATION
The mains plug of the drilling machine must be freely accessible.
3.4

Assembly

WARNING!
Danger of crushing when assembling and installing the
machine components.
Version 2.2.6 - 2020-07-21 Translation of the original instructions
B24H | B24HV | B28H | B28HV GB
27