Optimum OPTIDRILL B 17PRO Operating Manual page 25

Mounting of the drilling table support

Position the worm gear in the support
of the drilling table.

Adjust the toothed rack within the drill-
ing table support in a way that the
teeth of the toothed rack cam into the
spiral wheel of the support for the drill-
ing table support .
INFORMATION
The longer untoothed end of the rack must point upward.

Push the drilling table support with the toothed rack on the drill column.

Push the supporting ring onto the upright and the rack.

Tighten the screw of the supporting ring slightly. Make sure that the drilling table support
still can be easily turned around the upright.

Attach the clamping lever for drilling table fastening.
Fitting the drill head

Place the drill head on the drill upright
and turn it until it is aligned with the
base. Immobilise the drill head with the
two headless screws in the drill head
over the toothed rack.

Screw in the 3 levers of the spindle
sleeve feed and attach the crank of the
table height adjustment.

Insert the drilling table in the drilling
table support and clamp it with the
clamping lever.
Fitting the quick-action drill chuck

"Assembly quick- action drill chuck" on page 38
Assembly
Version 2.0.2 2014-11-04
Toothed rack
Clamping lever
Drilling table
support
Img.3-2:
Drill head
Lever
Spindle sleeve
lever
Drill upright
Img.3-3:
Drilling table
Clamping lever
Img.3-4:
Original operating instructions
OPTIMUM
M A S C H I N E N - G E R M A N Y
Mounting of the drilling table support
B26Pro
B26Pro
B17Pro | B23Pro | B26Pro | B33Pro GB
Page 25