Ndp Table - Panasonic PN28160K Operation Manual

4.6.11. NDP Table

On the Basic Switch Configuration Menu, pressing "D" opens the NDP Table
screen, as shown in Fig. 4-6-40. In this screen, you can refer and configure
NDP table.
PN28160K Local Management System
Basic Switch Configuration -> NDP Table
Sorting Method:
NDP Reachable Time: 30 Seconds
IPv6 Address
--------------------------------------- ----------------- ---------- -------
-------------------------------- <COMMAND> -----------------------------------
[N]ext Page
[P]revious Page
Set NDP [R]eachable Time
Set NDP Stale [T]ime
Command>
Enter the character in square brackets to select option
Screen Description
Sorting Method
Type
NDP Reachable Time
NDP State Time
IPv6 Address
Hardware Address
Status
Type
By IP
NDP Stale Time: 600 Seconds
Hardware Address Status
[A]dd/Modify Static Entry
[D]elete Entry
[S]orting Entry Method
[Q]uit to previous menu
Fig. 4-6-40 NDP Table
Shows the order of displaying.
By IP Shows the table in the order of IPv6 address.
By MAC Shows the table in the order of MAC address.
By Static Shows manually-set addresses.
By Dynamic Shows auto-learned addresses.
Shows the type on ARP table.
Static The address is manually set.
Dynamic The address is auto-learned.
Shows the NDP Reachable time.
Shows the NDP Stale time.
Shows the IPv6 Address on NDP table.
Shows the hardware address on NDP table.
Shows the IPv6 neighbor cache.
Shows the type on NDP table.
Static The address is manually set.
Dynamic The address is auto-learned.
111
Type