Table of Contents
Advertisement
4.10. Save Configuration to Flash
On the Main Menu, pressing "F" opens the Save Configuration to Flash
screen, as shown in Fig. 4-10-1. Execute this command to save the Switching
Hub configuration to the built-in memory. On this screen, the command
prompt shows "Save current configuration?(Y/N)." Press "Y" to save the
configuration. Press "N" to cancel it.
If you don't save the configuration on this screen, it will be deleted when the
system is rebooted or turned off.
PN28160K Local Management System
Main Menu -> Save Configuration to Flash
Save current configuration? (Y/N)>
Y for Yes; N for No
Fig. 4-10-1 Save Configuration to Flash screen: Confirmation to save
256
Advertisement
Table of Contents
