Damper Service - 30, Judy, Recon - Silver; 200 Hour Service; Damper Removal - Rock Shox 30 Service Manual

D a m p e r S e r v i c e - 3 0 ™ , J u d y ™ , R e c o n ™ - S i l v e r
2 0 0 H o u r S e r v i c e
Service procedures are the same for Motion Control™ (RL) and Turnkey™ (TK) dampers.
Inspect each part for scratches. Do not scratch any sealing surfaces
when servicing your suspension. Scratches can cause leaks.
When replacing seals and o-rings, use your fingers or a pick to remove
the seal or o-ring. Spray isopropyl alcohol on each part and clean with
a clean lint-free shop towel.
Apply Liquid-O-Ring® PM600 or SRAM® Butter grease to the new seals
and o-rings. If a brush is used to apply grease, confirm there are no
loose bristles in the grease or on the part.
30 Silver TK / Judy Silver TK / Recon TK / Recon RL: Turn the
1
compression adjuster knob to the full open position.
Remove the compression knob retaining screw.
Remove the knob.
Recon RL: Remove the detent spring.
30 Silver TK R / Judy Silver TK R / Recon TK R / Recon RL R: Remove
2
the remote spool retaining screw and remote spool.
D a m p e r R e m o v a l
N OTIC E
PM600
2.5 mm
Recon RL
2.5 mm
Damper Service - 30™, Judy™, Recon™ - Silver
SRAM Butter
62