200 Hour Service; Air Spring Removal And Service - Silver - Rock Shox 30 Service Manual

2 0 0 H o u r S e r v i c e
Verify all pressure is removed from the fork before proceeding. Depress the Schrader valve again to remove any remaining air pressure. Failure to do
so can result in injury and/or damage to the fork.
Inspect each part for scratches. Do not scratch any sealing surfaces
when servicing your suspension. Scratches can cause leaks.
When replacing seals and o-rings, use your fingers or a pick to remove
the seal or o-ring. Spray isopropyl alcohol on each part and clean with
a clean lint-free shop towel.
Apply Liquid-O-Ring® PM600 or SRAM® Butter grease to the new seals
and o-rings. If a brush is used to apply grease, confirm there are no
loose bristles in the grease or on the part.
Unthread the air spring top cap from the upper tube.
1
The air spring tube is attached to the top cap. Remove the top cap, air
tube and air spring assembly from the upper tube.
Clean the upper tube threads.
Remove the top cap.
2
Remove the air spring assembly from the air tube.
3
A i r S p r i n g R e m o v a l a n d S e r v i c e - S i l v e r
⚠ WARNI NG- EYE HAZARD
N OTIC E
PM600
24 mm

Air Spring Removal and Service - Silver

SRAM Butter
36