Air Spring Installation - Silver - Rock Shox 30 Service Manual

2 0 0 H o u r S e r v i c e A i r S p r i n g I n s t a l l a t i o n - S i l v e r
N OTIC E
Inspect each part for scratches. Do not scratch any sealing surfaces
SRAM Butter
when servicing your suspension. Scratches can cause leaks.
When replacing seals and o-rings, use your fingers or a pick to remove
the seal or o-ring. Spray isopropyl alcohol on each part and clean with
a clean lint-free shop towel.
Apply Liquid-O-Ring® PM600 or SRAM® Butter grease to the new seals
and o-rings. If a brush is used to apply grease, confirm there are no
loose bristles in the grease or on the part.
PM600
Apply grease to the air shaft.
1
Install the top out bumper, All-Travel spacer (if originally equipped, or
added if travel is reduced), and the negative air assembly onto the air
shaft.
Apply grease to the inside of one end of the air tube, approximately
2
60 mm into the tube.
Apply grease to the positive air piston and negative air seal head and
3
o-rings.
41

Air Spring Installation - Silver