Install U Bracket Mount; Components - U Bracket Mounting Assembly; Procedure - U Bracket Assembly; Torque Measurement - Honeywell Thor VM2 User Manual

Install U Bracket Mount

Note: This mounting system does not have provision for an integrated external keyboard mount or scanner holder. These
accessories can be mounted remotely if desired. Contact
CAUTION - This device is intended to transmit RF energy. For protection against RF exposure to humans and in accor-
dance with FCC rules and Industry Canada rules, this transmitter should be installed such that a minimum separation dis-
tance of at least 20 cm (7.8 in.) is maintained between the antenna and the general population. This device is not to be
co-located with other transmitters.
Before installation begins, verify you have the applicable vehicle mounting bracket assembly components necessary, as shown
in the following figures.

Components - U Bracket Mounting Assembly

The U bracket kit is available in two configurations:
• With a U Bracket included for new vehicle installations
• Without a U Bracket for installing the Thor VM2 in place of a previous Honeywell vehicle mounted computer, such as a
VX6 or VX7.
U Bracket (only necessary for new installations)
Adapter Bracket (includes screws, flat washers and lock washers to attach
Adapter Bracket to Thor VM2 and to U Bracket). The U bracket may already
be installed on the vehicle where a VX1, VX2, VX4, VX5, VX6 or VX7 was
previously installed.

Procedure - U Bracket Assembly

Equipment Needed: Sockets and a Torque wrench capable of measuring to 50 inch pounds (5.64±.56 N/m).
Note: Torquing tool is not supplied by Honeywell.

Torque Measurement

You will need a torquing tool capable of torquing to 35-50 inch pounds (1.10 N/m). Torque all screws and bolts accord-
ing to the following table:
For these bolts...
1/4-20x5/8 Bolts
M5x16mm Bolts
Technical Assistance
Torque to
50 in/lb (5.6 N/m)
35 in/lb (4.0 N/m)
(page 11-1) for details.
4 - 13