Processing - Honeywell Thor VM2 User Manual

Provided that the wedge is configured with the above table, below are examples of scanned bar code data and
results of these manipulations.
Bar Code Symbology
EAN-128
EAN-128
EAN-128
EAN-13
EAN-13
EAN-13
I2/5
I2/5
I2/5
I2/5
Code-93
Code-93
Code-39
Code-39 full ASCII
Code-39
Note: Rejected bar codes generate a bad scan beep. In some cases, the receipt of data from the scanner triggers
a good scan beep (from the external scanner), and then the rejection of scanned bar code data by the
processing causes a bad scan beep on the same data.

Processing

Start > Settings > Control Panel > Data Collection > Processing tab
The Processing tab contains a user configurable key delay that applies to scanned bar codes as they are input when
Remote Desktop is the application with the input focus.
Factory Default Settings
Enable buffered key output
Same buffer limit (characters) 32
Delay between (key) buffers
Note: Settings on this panel have no effect when RFTerm is the application with the input focus.
Enable buffered key output
Default is enabled (checked). Click the checkbox to turn off buffered key output.
Raw Scanner Data
]C11234567890123
]C111234567890123
]C1123
]E01234567890987
]E01231234567890987
]E01234
]I04444567890987654321 < rejected > (too long)
]I04444567890123
]I0444
]I022245622
]G0123456
]G0444444
]A01234567890
]A41231234567890
]A4
Enabled
75 ms
Resulting Data
bbb1234567890xxx
bbb11234567890xxx
< rejected > (too short)
ccc]E04567890yyy
ccc]E0234567890yyy
ccc]E0yyy
ddd7890zzz
dddzzz
ddd45zzz
< rejected > (disabled)
< rejected > (disabled)
aaa4567890www
aaa1234567890www
< rejected > (too short)
5 - 53