Maintenance - Vehicle Mounted Devices
Check the vehicle mounting hardware frequently and re-tighten if necessary.
If the vehicle mounting hardware and connections become broken, loose or cracked, the assembly must be taken out of service
and replaced. Contact
Technical Assistance
Cleaning
If it becomes necessary to clean the Thor VM2, dock, peripherals or mounting hardware see:
•
Cleaning the Thor VM2 and the Dock
•
Cleaning the Touch Screen
Place Thor VM2 in the Dock
Back of Thor VM2
Back of Thor VM2
1. Locate the notch on the upper rear of the Thor VM2.
2. Slide this notch over the top lip of the dock. Slide the Thor VM2 from side to side on the dock to make sure it fully engages
on the lip of the dock. If the Thor VM2 cannot be slid side to side, the lip is engaged.
3. Pull the quick release lever on the Thor VM2 down and push the Thor VM2 against the dock.
4. Release the quick release lever. The quick release lever catches the lower lip on the dock and secures the Thor VM2 to the
dock. Be sure the red quick release lever is pushed all the way in to secure the Thor VM2 to the dock.
5. If necessary, adjust the viewing angle of the Thor VM2.
When the Thor VM2 is placed in the dock, the following may happen:
• If the Thor VM2 is off and power is connected to the dock, the Thor VM2 may boot when placed in the dock. The behavior
depends on the Power Configuration Mode selected. See
• If the Thor VM2 is on and power is connected to the dock, the Thor VM2 power management timers may change when the
Thor VM2 is placed in the dock. See
When the Thor VM2 is removed from the dock, the following may happen:
• If the Thor VM2 is on and power is connected to the dock, the Thor VM2 power management timers may change when the
Thor VM2 is placed in the dock. See
4 - 2
(page 11-1) for help.
(page 2-10)
(page 2-10)
Notch on
Thor VM2
Release Lever
Power
(page 5-81).
Power
(page 5-81).
Front of Dock
Upper Lip on Dock
Lower Lip on Dock
Front of Dock
Ignition Control Mode
(page 5-83) and
Auto-On Mode
(page 5-84).