Power Controls; Power Switch; Power Button; Power Configuration Mode - Honeywell Thor VM2 User Manual

Power Controls

Power Switch

Power Button

Power Configuration Mode

The Power Configuration Mode control panel is used to select desired power configuration behavior.
Please refer to the
For information on the Ignition input signal see
Control Wiring Diagram
AC/DC
The Thor VM2 is powered on manually. Due to the presence of external power, longer default power management
timeouts are used.
Ignition Control
The Thor VM2 is configured to power on when the vehicle ignition is switched on. When the vehicle ignition is on,
longer default power management timeouts are used. If the vehicle ignition is turned off, shorter default power
management timeouts are used.
Auto-On
The Thor VM2 is designed to power on whenever external power is attached. Due to the presence of external
power, longer default power management timeouts are used.
UPS
The Thor VM2 uses the UPS mode whenever external power is not available. Due to the absence of external
power, much shorter default power management timeouts are used.
3 - 6
After all cables are connected, the Thor VM2 can be powered on.
There is a power switch located on the back of the dock. The power switch is a rocker
switch.
The power switch has a raised bump to identify the switch position even when it is hidden
from view. When the side of the switch with the raised bump is pressed, the power switch
is On. If the dock is connected to external power, the dock delivers power to the Thor VM2.
Generally, once the dock is powered On, there is no need to power it off. The dock power
can remain On even when the Thor VM2 is not attached.
Power Configuration Mode
(page 4-22).
The power button is located at the lower left of the Thor VM2.
If the Thor VM2 is Off, pressing the power button starts the power up
sequence.
Note: This assumes that the Thor VM2 is docked in a powered dock
or that the internal UPS battery has a sufficient charge to
power the Thor VM2. If no external power is available and the
UPS battery does not have a charge, pressing the power
button causes no action.
If the Thor VM2 is On, pressing the power button places the unit in
Suspend.
(page 5-83) control panel for complete details.
Vehicle 10-60VDC Direct Power Connection (page 4-20) and Auto-On