Querying Content Distribution Task; Figure 75 Querying Content Dispatch Task - Zte ZXBIV IPTV Operation Manual

ZXBIV IPTV MDP Operation Manual
Steps
Context
Steps
66 Confidential and Proprietary Information of ZTE CORPORATION
� After contents are distributed to the central node, content dis-
patch tasks to edge nodes are generated.
� In the content management module, content dispatch tasks
can be generated by manually copying content.
� To minimize bandwidth consumption and improve the usage
efficiency of the disk arrays on the edge nodes, content dis-
tribution policies can be set on the Portal. Content dispatch
tasks will be generated automatically according to the preset
content distribution policies.
� During the creation of relay channels, if the destination stream
media does not have the same default programs or SDP con-
tents of the source channel, content dispatch tasks will be gen-
erated automatically.
1. Click Task > Content Dispatch Task.
2. Specify query conditions such as VCDN name, Node name,
POP unit name, Target node, Destination POP unit, Sta-
tus, Start date, End date and Source FTP address.
If no parameter specified for a query condition option, this op-
tion will not be used as a filtering condition for the query result.
To reset the query conditions, click the Reset button.
3. Click the Query button to get the query result, as shown below.
F 75 Q
IGURE UERYING
E
ND OF STEPS
Querying Content
Distribution Task
Users can query the information of the content distribution tasks.
1. Click Task > Content Publish Task.
2. Specify query conditions such as VCDN name, Node name,
POP unit name, Content name, Status, Release type,
Start date and End date.
If no parameter specified for a query condition option, this op-
tion will not be used as a filtering condition for the query result.
To reset the query conditions, click the Reset button.
3. Click the query button to get the query result, as shown below.
C D T
ONTENT ISPATCH ASK