Toshiba B-EV4 Series Manual page 31

Notes (1) If the feed value fine adjustment, cut position (or strip position) fine adjustment or
back feed value fine adjustment has been set in system mode (key operation on
the printer), the fine adjustment value will be the fine adjustment in system mode.
The max. fine adjustment values are as follows. However, the max. feed fine
adjustment value is limited within the label pitch.
Feed value fine adjustment .........................................................±50.0 mm
Cut position (or strip position) fine adjustment............................±18.0 mm
Back feed value fine adjustment .................................................±9.9 mm
(2) After changing the fine adjustment value by this command, one label must be fed
by the Feed Command ([ESC] T) to adjust the first print position.
(3) Each fine adjustment value is protected in memory (even if the power is turned
off).
(4) If a fine adjustment value is improper, printing will not be performed correctly.
(5) The cut position (or the strip position) fine adjustment and back feed value fine
adjustment are effective only when the printer is in cut issue or strip issue mode.
For example, if the back feed fine adjustment value is not set properly,
the print positions without cutting and after cutting will be different from
each other. If the label is fed back excessively, the paper will not be fed
correctly during printing.
In the strip issue mode, the print position may differ between the first
label and the second label. The back feed fine adjustment is used to
adjust the length so that the label is correctly fed back to the position
placed before the forward feed is performed.
- 27 -