Strip Position Fine Adjustment; Back Feed Fine Adjustment; To Finely Adjust The Back Feed For Shifting Backward Or Forward - Toshiba B-EV4 Series Manual

[Strip Position Fine Adjustment]

0.0 mm
+3.0 mm
-3.0 mm
3 mm
2 mm
[Back Feed Fine Adjustment] (To finely adjust the back feed for shifting backward or forward)
0.0 mm
+3.0 mm
- 3.0 mm
Paper feed direction
Printing in strip issue mode is stopped at the position where the
distance from the middle point of the label-to-label gap to the
end of the strip shaft is 3 mm, since the label-to-label gap is
assumed to be 2 mm.
When the print stop position is not proper, the print stop position
should be adjusted using the strip position fine adjust function.
2 mm
When the label-to-label gap is 5 mm or more, the effective print
length should be set to the maximum (label pitch -2 mm). Then,
the print stop position should be adjusted using the strip
position fine adjust function.
First print position (home position after back feed)
First print position (home position after back feed)
First print position (home position after back feed)
- 26 -