Toshiba B-EV4 Series Manual page 26

Item
Thermal head dot density
Thermal head width
A: Label/tag pitch
B: Label length
C: Backing paper width/ Tag width
D: Label width
E: Label-to-label gap length
F: Black mark length
G: Effective print width
H: Effective print length
I: Slow up/ down interval
J: Thickness
Notes (1)
(2)
(3)
(4)
(5)
(6)
Model
Issue mode Batch
Min.
Label
Max. 999
Min.
Tag
Max. 999
Min.
Max. 997
Min.
Max.
Min.
Max.
Min.
Max.
Min.
Max.
Min.
Max.
Min.
Label
Max. 995
Min.
Tag
Max. 997
Slow –up
Slow-down
Label
Tag
Before changing the label size or type of sensor, the Label Size Set Command
must first be transmitted.
The Label Size Set Command is protected in memory (even if the power is turned
off).
After sending the Label Size Set Command, one sheet of paper must be fed by
the Feed Command ([ESC] T) and must be aligned with the first print position prior
to printing.
The origin of drawing coordinates, print stop position (head position at stop), and
cut position are determined according to the parameters of the Label Size Set
Command as shown in the figure on the preceding page. For the print stop
position in strip issue mode, refer to the section of the Position Fine Adjust
Command. The effective print area is centered on the label/tag.
Printing cannot be performed in the slow up (1 mm) and slow down (1 mm) areas.
Consequently, [A : label/tag pitch] - [H: effective print length] ≥ 2 mm must be
assumed.
The origin of drawing coordinates, print stop position (head position at stop), and
cut position are adjustable by the Fine Adjust Commands and according to the
fine adjustment settings in System mode.
203 dpi model
Strip Cutter
8 dots/mm (203 dpi)
108
10 25.4 25.4
152.4 999
10 --- 25.4
--- 999
8 23.4 19.4
150.4 993
2.0 6.0
2.0 6.0
13
108
6 21.4 17.4
148.2 991
8 --- 25.4
--- 997
60µm to 190µm
60µm to 190µm
- 22 -
300 dpi model
Batch Strip
11.8 dots/mm (300 dpi)
105.7
10 25.4
457.2 152.4
10 ---
457.2 ---
8 23.4
455.2 150.4
25.4
112
22.4
109
2.0
10.0
2.0
10.0
13
105.7± 0.2
6 21.4
453.2 148.2
10 ---
455.2 ---
1.0
1.0
[mm]
Cutter
25.4
457.2
25.4
457.2
19.4
451.2
6.0
6.0
17.4
449.2
25.4
455.2