Cut Interval - Toshiba B-EV4 Series Manual

g:
h:
Explanation (1) Number of labels to be issued
(2)

Cut interval

The cut interval is valid only when the cutter has been installed and the issue
mode is "C" of "F". If an error occurs during an issue after the cut interval is
designated, and then printing is restarted, the printer ejects the printed paper then
resumes printing on the paper where the error occurred.
If no subsequent command is received from the PC for 3 seconds after cut-issuing
the last label, when the cut interval is valid and "with automatic forward feed
standby" set in the system mode, the printer automatically performs a 16.3-mm
forward feed.
When the Issue Command is received during the automatic forward feed standby,
an issue is started after a reverse feed to the original position.
If any command is sent and processed after the Issue Command is sent, the
automatic forward feed is not performed. Therefore, a command should not be
sent after the Issue Command is sent. If the power should not be turned off then
on, or the printer should not be placed in a pause/reset state before the automatic
forward feed, since the automatic forward feed is not performed when the paper is
fed by turning the power off then on, or by pressing the [FEED] key of the printer
in the pause/reset state.
If the paper is fed by pressing the [FEED] key of the printer during the forward
feed standby, the printer feeds one label, cuts, performs the automatic forward
feed then stops.
(3) Type of sensor
Designates tag rotation.
0: Printing bottom first
1: Printing top first
2: Mirror printing bottom first
3: Mirror printing top first
Type of status response
0: No status response
1: Status response
If increment/decrement is not specified, the designated number of pieces with
the same drawing data will be issued.
If increment /decrement is specified, the designated number of pieces will be
issued while incrementing/decrementing the piece of the designated drawing
area.
* The increment/decrement designation is valid until the Image Buffer Clear
Command ([ESC] C) is transmitted.
No sensor: Printing takes place according to the parameter designated by the
Label Size Set Command.
Note: When the "F: Partial cut mode" is designated for the issue
mode, "No sensor" should be selected. (The partial cutter is
supposed to be used for cutting continuous media, like receipt
rolls.)
- 119 -