Sealed Engine Mounting; Lens Holder; Lens Holder Swapping - Barco RLM G5 Performer Service Manual

8.9.2

Sealed Engine mounting

How to mount the Sealed engine
1. Place the sealed engine on its mounting base, lining up the 2 center pins (1 & 2) on the engine front plate with the holes in the
mounting base. (image 8-34)
2. Secure the sealed engine onto the mounting base with 3 screws (A, B & C) (image 8-31).
3. Go back to the chapter 'Sealed engine removal' to reinstall all cable connections and Fan mounting (see "Sealed Engine removal",
page 38).
A
1
B
Image 8-34
Sealing engine mount

8.10 Lens Holder

8.10.1 Lens Holder swapping

How to swap the lens holder
1. Disconnect the lens holder motor wires from the motor control board. (image 8-35)
2. Remove the 5 screws (1=long - 2 to 5 short) securing the lens holder to bottom frame. (image 8-36)
3. Move lens holder upwards to remove.
Lens Holder
Motor Up/Down
J24
Lens Holder
Motor Left/Right
J26
Image 8-35
Lens holder motor disconnection
R5976766 RLM G5 22/04/2004
2
C
1
2
8. Module/Unit Identification
Lens Zoom
Motor
J21
Lens Focus
Motor
J23
41