Input Box Complete; Input Box Swapping - Barco RLM G5 Performer Service Manual

Image 8-13
Power box fixation

8.4 Input Box Complete

Overview
•

Input Box Swapping

• Parts of the input Box Assembly
8.4.1 Input Box Swapping
Access to Input boards
1. Remove the 3 screws securing the PMP board to the input box (1) and to the formatter interface board (2&3). (image 8-14)
2. Carefully unplug, by pulling the PMP board upwards, the PMP board from the input backplane (B) and the formatter interface
board (A) (image 8-14).
3. Remove the 2 screws (3&4) securing the formatter interface board to the power box. (image 8-15)
4. Remove the 2 screws (1&2) securing the formatter interface board to the input box (image 8-15).
5. Loosen the 2 captive screw (1&2) securing the input box to projector bottom. (image 8-16)
6. Disconnect input box by pulling out the 3 respective power plugs (A,B&C).
7. Pull the input box upwards to take out the projector main frame.
R5976766 RLM G5 22/04/2004
C
D
A
B
E
8. Module/Unit Identification
31