Technical Specifications; Rlm R5 Performer - Barco RLM G5 Performer Service Manual

Led 3 lights up Green and flashes 60s
Led3
Led2
Led1
Turn on again the projector
MCU Board
J25
J26
J24
D3
Led1and Led2 light up Red
Lamp Lit NOK Replace the NOK
Lamp module
and then Off
OK
The Led 3 lights: 2 sec
Check on MCU Board
Led D3
The Led 3 lights: 4 sec
The Led 3 lights always
The Led 3 do not light
Replace the
Check the cable between NOK
Ballast and MCU Board Cable
OK
Check on MCU Board
NOK Replace the
J203[3]=+5V
MCU Board
J213[3]=+5V
OK
Check on MCU Board
Replace the
NOK NOK
J203[4] and J213[4]
MCU Board
Hi(+5V) to Low transition
when turning on
OK
Replace the NOK Replace the NOK
Lamp Power Supply PMP Board
On the MCU Board
Failure:
OK
Pull out the cable plug on
Powergood error
J24/J25/J26
Failure:
OK
Fan error
OK
Replace the Temperature
Sensor in the lamp module
OK
Replace the MCU Board
Trouble Shooter RLM G5P
Led1 and Led2 light up Red
Led 3 lights up Green and flashes 60s
Check cable between
Replace the
NOK
J506 MCU Board and
Cable
J304 Adapter Board
OK
Replace the
Adapter Board
NO
On the free cable plugs,
measure the voltage level
at pin 1 of the plug:
+5V?
YES
For the Fans not controllable
by naked eye
In the cool down period
Check the Fans on
OK
of 60 sec measure voltage
rotation
at pin 1 of the Fan plug
by naked eye
NOK NOK
On the MCU Board
OK
Insert the Fan plug of
Replace the MCU Board
the non rotating Fan in an
other Fan connector
NOK
Replace the Fan
Replace the respective Power Board
on which cable plug no +5V
has been measured
Replace the MCU Board