BONFIGLIOLI Active ACT 201-05 Brief Manual page 51

Analog Operation
... 10 V) which is proportional to an actual value.
Setting:
Motor Temp. Operation Mode.
drive system. Connect a suitable sensor to digital input S6IND.
Setting:
Operation Mode
useful in some applications such as pumps and fans or after acknowledgement of an
error switch-off. If synchronization to the motor speed is not possible, the function is
quit and a fault message is issued.
Setting:
Operation Mode
accordance with VDE 0113 (Section 5.4, 5.5), VDE 0100 Part 227 and the national
regulations. Make sure that automatic startup does not result in any dangerous
situation.
Setting:
Operation Mode
operation and/or deceleration operations, is limited by means of the voltage
controller or an external braking resistor in order to avoid an error switch-off due to
overvoltage.
Setting:
The following parameters are displayed in addition to the basic parameters in
configuration 410.
Integral Time 1
depending on the mechanical moment of inertia, via the integral time of the speed
controller. The lower the value is, the more dynamic the behavior. The increase in
inherent instability of the system is proportional to the reduction of the integral time.
Setting:
Current Limit
configuration 410. The torque is limited to the rated torque if the current limit is the
same as the
Setting:
I
inverter
06/05
06/05
553 - output MFO1 supplies a pulse width modulated signal (0 V
7 - actual frequency, 0 Hz ...
20 - active current, 0 A ... I
30 -
active power P
50 - effective current, 0 A ... I
52 - machine voltage, 0 V ... 1000 V
0 - thermo-contact switched off
1 - thermo-contact warning message
2 - thermo-contact error switch-off
3 - Thermo-contact error switch-off after 1 min
4 - Thermo-contact error switch-off after 5 min
5 - Thermo-contact error switch-off after 10 min
645 (for synchronization) - synchronization to a rotating drive is
0 - switched off
10 - synchronization switched on, quick synchronization
651 - automatic startup of the drive is permissible only in
0 - switched off, control signal at S1IND, S2IND or S3IND
1 - automatic startup, control signal at S1IND, S2IND or S3IND
670 - the DC link voltage, which increases due to generatoric
0 - switched off, limited by connected brake resistor
1 - overvoltage controller, controlled deceleration ramps
722 - the control behavior of configuration 410 is to be adapted,
0 ... 60000 ms
728 - the speed and torque can be controlled separately in
Rated Current
0.0 A ... o⋅I
U P : nominal values of frequency inverter, o: overload capacity of the frequency
FIN, FIN, FIN
Maximum Frequency
FIN
, 0 kW ...
wirk
FIN
570 - monitoring the motor temperature protects the
371 of the motor.
FIN
419
Rated Mech. Power
376
49
49