Kyocera TASKalfa 420i Operation Manual page 286

Default Setting (System Menu)
4
Use [+]/[-] or the numeric keys to enter an address number (1 to 2500).
To have the number assigned automatically, set "0000".
NOTE:
Address Number is an ID for a group. You can select any available number out of 2,000 numbers for
contacts and 500 numbers for groups.
If you specify an address number that is already in use, an error message appears when you press [Register]
and the number cannot be registered. If you set "0000" as the address number, the address is registered under
the lowest available number.
5
Press [OK]. The Add Group screen reappears.
6
Press [Change] of Name.
7
Enter the group name displayed on the Address Book not more than 32 characters.
NOTE:
8
Press [Member].
9
Press [Add].
10
Select destinations (contacts) to add to the group.
NOTE:
Specifying Destination on page 3-30 for Address List.
11
Press [OK].
If you have more destinations to add, repeat Steps 9 to 11.
12
Check if the selected destination was added to the group and press [Register]. Now the group is added to
the Address Book.
Editing a Destination
Edit/delete the destinations (Contacts) you added to the Address Book.
Use the procedure below to edit a destination.
1
Press the System Menu key.
2
Press [Edit Destination] and then [Register/Edit] of Address Book.
3
Select a destination or group to edit.
NOTE:
Destinations can be sorted or searched by destination name or address number. Refer to Specifying
Destination on page 3-30 for Address List.
4
Press [Detail].
The procedure differs depending on the details to be edited.
8-54
Downloaded from www.Manualslib.com
Refer to the Character Entry Method on Appendix-10<blue> for details on entering characters.
Destinations can be sorted or searched by destination name or address number. Refer to
manuals search engine
OPERATION GUIDE