Kyocera TASKalfa 420i Operation Manual page 252

Default Setting (System Menu)
Use the procedure below to set the default e-mail subject and message body.
1
Press the System Menu key.
2
Press [Common Settings], [
3
Press [Subject] to enter an E-mail subject not more than 60 characters.
NOTE:
Refer to the Character Entry Method on Appendix-10<blue> for details on entering characters.
4
Press [OK].
5
Press [Body] to enter an E-mail Body not more than 500 characters.
6
Press [OK].
7
Check that the entries are correct and press [OK].
Border Erase Default
Set the default width to be erased as a border. The table below shows the measurement ranges that can be set.
Inch
Metric
NOTE:
Refer to page 4-17 and page 5-23 for Border Erase.
Use the procedure below to set the default border erase width.
1
Press the System Menu key.
2
Press [Common Settings], [
3
Press [+] or [–] for the Border and Gutter width to erase.
You can use the numeric keys to enter the number directly.
4
Press [OK].
Border Erase to Back Page
Select the Border Erase Method for Back Page of a sheet. The table below shows the available settings.
Same as Front Page
Do Not Erase
8-20
Downloaded from www.Manualslib.com
], [Next] of Function Defaults, [
Input units
0 to 2" (in 0.01" increments)
0 mm to 50 mm (in 1 mm increments)
], [Next] of Function Defaults, [
Item
Border Erase performed in the same setting as the front page
No Border Erase performed on the back page
manuals search engine
], and then [Change] of E-mail Subject/Body.
Range
] and then [Change] of Border Erase Default.
Description
OPERATION GUIDE