Fill Material Cart And Print Tray With Material - 3D Systems ProJet 6000 User Manual

FILL MATERIAL CART AND PRINT TRAY WITH MATERIAL

1 . Open the lower chamber door .
2 . Press the release button and extend the material bottle holder .
3 . Install a full bottle of material. Make certain to press down firmly
on the material bottle so the connector on the bottom of the bottle
fully engages the coupler located in the bottom of the holder .
4 . Push the holder back into place .
5 . Close and lock the lower and upper chamber door .
6 . On the GUI, select Advanced >
7 . Press Level Print Tray .
3D Systems, Inc.
Elevator/Leveler .
56